Hi
I am working on a Yeasu FL2100B that I had to replace the band switch due to
fried switch contacts (output side). Now that it is fixed I still have no
output. When I apply drive I get some plate current (very little output) and
can get a dip with the plate cap. However the loading cap has no affect at
all. More drive does not help either. Are there some checks I can make to
narrow this down. If the tubes are bad is there a way to check them?
Thanks
Dan AF9R
DanAF9R@aol.com
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|