Fellows, Four questions at the end. Have just bought an Omni VI Plus manufactured in mid-1998 with optional 1.8 kHz SSB filters in the 6.3 and 9 mHz IF strips. (I think I am all set up for SSB). I be
My Omni VI Plus main tuning knob had binding over a 90-degree section of rotation, from 9 o'clock to 12 and it took all the fun out of tuning the bands. Posters in the Archives have discussed repair
Hello, Want to buy filter 282 for the OMNI VI Plus: 250 Hz CW filter for the 6.3 MHz adjustable passband IF. Please respond off list to peter at nednet dot net. Thank you, Peter Nederland, Colorado _
I'm new to SMT and am following the INRAD instructions for improving the SSB audio response of the OMNI VI+ . If you have done the mod, your probably can help me. Here are the INRAD instructions: "Re
You need to implement the internal Omni VI+ forward power (and other) transmitter alignment instructions found on pages 4-6 and 4-28 of the Omni VI+ manual. Do the bias adjustments on page 4-28 first
Andy, Just finished a complete Omni VI+ Xmtr and Rcvr alignment. Xmtr now draws 12 amps for 100 watts out, but before alignment, drew 18 watts for 100 watts out. You might want to hook up a 25 amp me
Dave, K2DP Below is a re-post from last May 2006 of my repair procedure for an Omni VI binding main knob problem. Hope this helps you and others who may have the same problem. Peter, VE1CHS My Omni V
Fellows, Have the model 221 "low note" 250 Hz 9Mhz IF filter. On my Xceiver, an Omni 6 Plus, late serial number, it is in the "N-2" position. Am aligning my S meter with a 50 uV signal from Calibrate
Jerry, K0CQ, Nope, there is no jumper across the missing capacitor slot. It is just plain missing. Jerry, according to my translation from the handbook, the missing 102J small, blue, low voltage, pol
Fellows, Am hearing disabled, own an Omni 6 Plus mostly for CW, and cascade the 250 Hz 6.3 IF CW filter along with the "low note" 221 250 Hz CW filter in the 9 mHz IF (position N-2). In reality, my s
Fellows, Have you got suggestions for the case of intermittent power out from an Omni VI Plus? First year (May 2006 - March 2007) since I am the second owner, no intermittent noticed; always got full
Fellows, Tks for many useful posts on thread "Omni VI + Intermittent Power Amp?". Will post results on this later after further testing; so far glitch has not returned and am looking good on this one
Do you still have the Autek RF 1. Is it in good condition? Peter Nederland, Colorado VE1CHs _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.cont
This progress note is in reference to previous thread: Omni VI Plus rig sometimes would put out full power, but at other times, failed to put out more than 5 W. Finally had time to debug; many thanks
Many thanks to Dan, N4VET. Dan was correct: in the Omni VI Plus manual, the instructions for adjusting transmit bias are incorrect. A crucial sentence had been left out from this 1997 version of the