I'd be curious to see what test program you used for this. The same test should give you very close results. Doug Harman KarlNet, Inc. 525 Metro Place North Suite 100 Dublin, OH 43017 614 822-5275 x
The FCS errors happen when only a partial frame makes it across the connection. So if interference/noise steps on the frame, or if the link is marginal, or if there is a bad connection in the cable,
We recommend using a radius server or the access control list to keep unauthenicated users off of your network. We will also release 802.1x in our version 4.12 release that will provide better securi
FCS are per radio in either a point to point or multi-point Doug Harman KarlNet, Inc. 525 Metro Place North Suite 100 Dublin, OH 43017 614 822-5275 x 123 614 822-0024 fax
Rod, there should be activity on the wireless LED of a packet sent about 1 time per second. If you don't see that then the unit would be locked. Doug Harman KarlNet, Inc. 525 Metro Place North Suite
I have found the best way for me is to put the driver onto a floppy disk. Then when you are in Device Manager go to the Properties of the Wireless card and then the Driver Tab. Select Update driver a
There was a box a from Bay Networks that pinged the Base or Satellite and when it didn't get a ping response it turned off and then back on the power. I can't remember the name of the unit, but this
I'm not surprised. Microsoft wants to tell you what driver to use and doesn't trust that you can pick one out yourself. XP is even worse. I haven't seen or heard of your error message. I would think
All, Kevin Knuth has exited the list!. My name is Reg Mallory, I am the Technical Services Manager with KarlNet,Inc. I will monitor and respond to this list at every opportunity. My goal is to perfor
These parameters were tested with -79dbm rx sensitivity or 24Mbps OFDM rate in G-mode. At this scenerio, the average PtP throughput was 14.75Mbps.The PtMp yielded 11Mbps average, with six satellites
Dan, the Dev. Engineer is onsite this week reviewing ALL submitted information. The moment that I receive an update I will provide/relay the solution. The Testlab has replicated the issue and provide
Brett, We have provided this information on our web site. Here is the URL: http://www.karlnet.com/Product/ProductFlashROM.htm EvD KarlNet Technical Support --Original Message-- From: karlnet-bounces@
Dan, The KN-205 are designed with an operating temperature of 185 degrees Fahrenheit. All KN-2xx units sold know are the 205 is this not suitable for your situation? Thanks, Ed KarlNet Technical Supp
Sergey, Was this a new install? If not did you regenerate your license key? Ed KarlNet Technical Support http://www.karlnet.com/Support/Supportmain.htm 614-822-5275 x 128 --Original Message-- From: k
yup...is karlnet sleeping? I sent an email to support (like Kevin requested) a few days ago......I realize it's a holiday week but ....are there that many support e-mails to attend to? I can't imagin
All, KarlNet Technical Support/Services never sleeps. We apologize for the delay of email responses, we will address all ASAP.The holiday season and end of year processes has delayed email responses.
Roberto,this card is NOT supported by SC-4700 NDIS, please see below: PRESS RELEASE KarlNet Announces Low-Cost Hardware Replacement to SC-4700 Client Drivers Dublin, OH ? September 15, 2003 ? KarlNet
Try attached method. --Original Message-- From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]On Behalf Of helio@compuland.com.br Sent: Wednesday, November 12, 2003 9:01 AM To:
This feature(NAT/DHCP) has been returned to the license-it site. We apologize for any inconvenience this may have caused. Thanks for all the valuable feedback!. KarlNet Support RLM Just FYI, not tryi