The FCS errors happen when only a partial frame makes it across the
connection. So if interference/noise steps on the frame, or if the link is
marginal, or if there is a bad connection in the cable, then FCS errors will
go up. Typically on a wireless link you will see these errors. A rule of
thumb is if they are above 10% of bytes in then you have a major problem.
Doug Harman
KarlNet, Inc.
525 Metro Place North
Suite 100
Dublin, OH 43017
614 822-5275 x 123
614 822-0024 fax
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> Behalf Of Dan Metcalf
> Sent: Wednesday, May 22, 2002 1:03 PM
> To: 'karlnet@WISPNotes.com'
> Subject: RE: [Karlnet] In Errors/FCS Errors
>
>
> I see a high number of In Errors/FCS Errors on my AP, should I be able to
> match these errors w/ outbound errors at my CPE? Or could random *noise*
> cause these as well?
>
> Dan Metcalf
> Wireless Broadband Systems
> dan.metcalf@wbsysnet.com
> 781-658-2075
> www.wirelessbroadbandsystems.com
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|