Hi, There is a utility on the radio which allows you to see either the IP or MAC along with the packet traffic. I cant seem to remember where it is. Can someone point me too it. Thanks, Eric -- Eric
I am pulling my hair out. I have a SEC client RG with 4500 loaded. It sees the AP but wont ping it. The AP is wide open without restrictions. Everything is on the same subnet. Laptop pings RG via eth
I have an RG with SEC. I changed the IP address from xx.xx.xx.5 to xx.xx.xx.51. When I re-scan for it, the .5 shows up. I go into setup and under IP host, .51 is there. I can ping both. Is that weird
Hello listers, I am running an AP1000 with ISP upgrade KarlbridgeRouter V4.27 snxxxxxxxxxxxx V3.70. What should the pccard version be to avoid issues and where on the cofigev do I located the version
After installing SR4000 on RG. I have 4 red leds upon scanning for RG. The forced reload procedure found in doc's doesnt seem to work. Press reset, wait 5 sec for restart of RG and then hold reload f
Documents from License-it site say to reinstall new bin file by following this procedure. Can someone tell me where to find it please. Thanks, -- Eric L. Johnson WarpSpeed Internet 1-361-563-3742 --
Bob, Thanks for the reply but please see notes within: Done no problem Done, no problem Done, so far so good. Scan for Cant find the device. I turn around and all red leds again. I have to put it bac