| To: | tentec <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Question about the use of the RX antenna port present on some TT transceivers |
| From: | Carlos <carlos.peco@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 9 Mar 2019 13:27:06 +1100 |
| List-post: | <mailto:tentec@contesting.com> |
Hi,
Some TT radios have an RCA connector marked as "RX Antenna", together
with a "RX / TRX" switch.
I cannot make sense of the user manual (perhaps because I'm not a
native speaker) and by looking at the schematics (Corsair II) I cannot
fully determine what this connector does in both TX and RX for both
switch positions.
- Is that connector to use a separate RX antenna system, or is it
to feed auxiliary receivers with a sample from the main TRX antenna?
- What is the isolation between the main antenna port and than
"RX antenna" port?
73,
Carlos VK1EA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Omni-C Power Switch Challenge, James Boswell |
|---|---|
| Next by Date: | Re: [TenTec] Question about the use of the RX antenna port present on some TT transceivers, Carl Moreschi |
| Previous by Thread: | [TenTec] Omni-C Power Switch Challenge, Jim C |
| Next by Thread: | Re: [TenTec] Question about the use of the RX antenna port present on some TT transceivers, Carl Moreschi |
| Indexes: | [Date] [Thread] [Top] [All Lists] |