| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Wanted A9 Power Distribution board. |
| From: | Dan Presley <n7cqr@arrl.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 9 Dec 2018 15:19:15 -0800 |
| List-post: | <mailto:tentec@contesting.com> |
Whoa-thanks for the heads up! I’ll check it out. Thanks Dan Presley 503-701-3871 danpresley@me. com N7CQR@arrl.net > On Dec 9, 2018, at 15:14, Richard W. Froiseth <Rfwd6dok@centurylink.net> > wrote: > > To All, > > I am looking for a A9 Power Distribution board for an Omni II. > Would prefer the board to have all the original Caps installed. > > 73’s > Rich, WD6DOK > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Wanted A9 Power Distribution board., Richard W. Froiseth |
|---|---|
| Next by Date: | Re: [TenTec] list opinion(s) on Omni VII and/versus Orion, Mark |
| Previous by Thread: | [TenTec] Wanted A9 Power Distribution board., Richard W. Froiseth |
| Next by Thread: | [TenTec] WTT filter, Michael Tortorella |
| Indexes: | [Date] [Thread] [Top] [All Lists] |