| To: | "'tentec@contesting.com'" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Omni VI Plus PA Bias |
| From: | "Gary Hendricks" <k4mt1950@charter.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 24 Apr 2018 02:52:33 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
I just looked at the Omni V manual and it is adjusted just like mine was. If so procedures I have seen here will cause too much driver bias and not enough pa bias. The Omni V says adjust driver bias for 50 MA increase and PA bias for 500 ma increase. OK Guys which is right? Gary K4MT _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] PA Bias Omni VI Plus, Gary Hendricks |
|---|---|
| Next by Date: | [TenTec] Omni VI PA bias update, Gary Hendricks |
| Previous by Thread: | [TenTec] PA Bias Omni VI Plus, Gary Hendricks |
| Next by Thread: | [TenTec] Omni VI PA bias update, Gary Hendricks |
| Indexes: | [Date] [Thread] [Top] [All Lists] |