| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni VI Plus front panel |
| From: | Barry N1EU <barry.n1eu@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 23 Apr 2018 20:02:21 +0000 |
| List-post: | <mailto:tentec@contesting.com> |
The buttons/switches are shown in figure 4-34 on page 4-33 Barry N1EU On Mon, Apr 23, 2018 at 6:30 PM, Gary Hendricks <k4mt1950@charter.net> wrote: > I can not find a schematic that shows the MS MT LP AND NR buttons and > where they go to on I assume the logic board. Anyone know where that > schematic might be found > Gary K4MT > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec > _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Omni VI Plus front panel, Gary Hendricks |
|---|---|
| Next by Date: | Re: [TenTec] Omni VI Plus front panel, k4mt1950 |
| Previous by Thread: | [TenTec] Omni VI Plus front panel, Gary Hendricks |
| Next by Thread: | Re: [TenTec] Omni VI Plus front panel, Barry N1EU |
| Indexes: | [Date] [Thread] [Top] [All Lists] |