| To: | <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Centurion |
| From: | "Robb Urie" <rurie@bajabb.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 2 Sep 2017 10:49:11 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
Had the same scenario 10 years ago; one cap blew and loss of HV. Replaced
all caps and checked diodes...fairly common due to the age/quality of caps
used. Hardest part is removing board since you have to unsolder the
filament leads.
Replacement caps came from Allied electronics. Good luck and be careful.Robb N0RU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Blown up Centurion, Michael C. Marx |
|---|---|
| Next by Date: | Re: [TenTec] Blown Up Centurion, David Propper |
| Previous by Thread: | [TenTec] Blown Up Centurion, Michael C. Marx |
| Next by Thread: | [TenTec] Orion 565 and N1MM+ Warerfall display?, Eric Rosenberg |
| Indexes: | [Date] [Thread] [Top] [All Lists] |