Re: [TenTec] Omni VI questions

[Stan Gammons <s_gammons@charter.net>]

On 07/30/2017 02:04 PM, Barry N1EU wrote:
> Stan, if the 288 filter is plugged into your 9MHz i.f. board, remove it and
> install it properly on the PBT board.  That is a 6.3MHz i.f. filter.
>
> 73, Barry N1EU
Hi Barry,

Yep, it looks like someone put that filter in the wrong slot.  I put it 
on the PBT board and the 1.8 Khz bandwidth setting works now. Thanks!
I sent a message to the list with a pic of the 2 filters attached. But, 
it was too large and got put on hold.
Thanks again for your help.


73

Stan
KM4HQE