[TenTec] Eagle CAT com port goes dumb on transmit

["Michael Tortorella" <w2iy@verizon.net>]

Hello to the list, I am using DXLab and N1MM+ with my Eagle.  Both programs
work nicely until I press the key, then the com port goes dumb and the PC no
longer follows the radio.  Sure sounds like RF is getting into the PC, so I
have disconnected all the cables (power and LAN) and put ferrites on the USB
cable to the Eagle but this has not solved the problem.  The PC is a Toshiba
Satellite C55 laptop, I do not see any place where I can ground the case to
the radio which I would like to do.  Any other suggestions I can try?

Thanks in advance for any help.  73, Mike W2IY



---
This email has been checked for viruses by AVG.
http://www.avg.com