| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] HELP with broken off screw threads |
| From: | Barry N1EU <barry.n1eu@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 24 Dec 2016 15:02:05 +0000 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
The threaded end of an aluminum screw broke off in one of the PCB mounting posts in my Omni 6+. Please have a look here: http://n1eu.com/screw1.jpg I'd very much appreciate advice on how to remove that screw end. Thanks & 73, Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Looking for Herc II, Bob Good |
|---|---|
| Next by Date: | Re: [TenTec] HELP with broken off screw threads, Peter Frenning [OZ1PIF] |
| Previous by Thread: | [TenTec] Looking for Herc II, Michael Tortorella |
| Next by Thread: | Re: [TenTec] HELP with broken off screw threads, Peter Frenning [OZ1PIF] |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
