John, I remember reading that now that you mentioned it! HI
I just couldn't remember where I had looked. Boy, does time
do a number on us. HI
Clayton N4EV
--------------------------------------------
On Sat, 5/21/16, John / K4WJ <k4wj@att.net> wrote:
Subject: Re: [TenTec] Keying the Omni VI Plus in Standby Mode
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Date: Saturday, May 21, 2016, 12:59 PM
I received a couple of direct e-mail
responses and the solution is to
hit the ST button and then the CW button. One guy told me
that I posted
this to the TT reflector back in 2010. :-)
73..de John/K4WJ
On 5/20/2016 7:19 AM, Barry N1EU wrote:
> Have you tried removing the TX EN/TX OUT jumper?
>
> 73, Barry N1EU
>
> On Fri, May 20, 2016 at 6:11 AM, John / K4WJ <k4wj@att.net> wrote:
>
>> It has been a couple of years since I've used my
Omni VI Plus and I've
>> forgotten how to set the rig in standby and still
key the side tone
>> oscillator. I used to be able to do this without
even thinking about it and
>> now I can't remember.
>> I don't remember finding instructions in the
manual, but I searched it in
>> case I was wrong about that, and, I couldn't find
anything. It seems like I
>> learned how to do this from someone on this
reflector.
>> Does anyone know how I can key the side tone
oscillator without emitting
>> RF?
>>
>> --
>> 73..de John/K4WJ
>> ex KN8PXG K8PXG K8WJ ZF2HZ
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
73..de John/K4WJ
ex KN8PXG K8PXG K8WJ ZF2HZ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|