Hi Rick,
Yes I am planning to do that but I don't have the PS here. I'd still like to
find a schematic for it. Thanks anyway.
73, Tony VE3DWI.
Sent from my BlackBerry 10 smartphone on the Bell network.
Original Message
From: rick@dj0ip.de
Sent: Thursday, November 19, 2015 02:23
To: 'Discussion of Ten-Tec Equipment'
Reply To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Ten-Tec 262G P.S.
Tony, that's pretty easy to see.
All you have to do is pull the skins.
Of the 4 pins, one is ground, one has a big thick wire going to it; 13v.
Two have thin wires going to them. They switch the AC.
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Tony
Lelieveld
Sent: Thursday, November 19, 2015 3:50 AM
To: tentec@contesting.com
Subject: [TenTec] Ten-Tec 262G P.S.
Hi all,
I am looking for a schematic for this power supply. A friend got one without
a radio. It has the knobs on the front for a VOX system too but that is not
important. We need to know which 2 pins need a jumper on the plug at the
back so he can switch it on/off with the button on the front. Any info will
be much appreciated.
73, Tony VE3DWI. email (VA3DWI at gmail.com).
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|