I’d check the output filters. The relays have a tendency to go kaput. If you
can monitor DC input current, that would be helpful. If you’re drawing 15 amps
and getting 10 out, then output filters would be a good place to start.
You didn’t mention if it was on one band or all bands.
Try using the separate antenna input to see if your receiver comes back. That
jack bypass the filter board and swr/alc board.
Mike Bryce WB8VGE
“The trouble with quotes on the Internet is that you never know if they are
genuine”
—Abraham Lincoln
> On Jul 8, 2015, at 8:08 AM, Dave Edwards <kd2e@comcast.net> wrote:
>
> All bands?
>
>
>
>
> On 7/8/15 12:31 AM, Paul DeWitte wrote:
>> A couple of days ago while in QSO my Omni VI+ lost both rcv and TX.
>>
>> Into a dummy load it shows about 5 watts reflected with about 10 watts
>> drive. I tried this with 2 different dummy loads and 2 different
>> meters, plus on the meter on the radio in the SWR position all same
>> results.
>>
>> Until this happened, it had worked flawlesly for years.
>>
>> It is like a short across the output/input. Has this happened to
>> anyone on here? Or have an idea what the problem could be?
>>
>> At $110 per I am not anxious to donate to the TT relief fund if I can
>> fix it myself.
>>
>> Thanks, 73
>> Paul K9OT
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|