Bob:
I'm sorry to hear about the problem with your Orion II reprograming. This is
one area where I would have to ask the experts on the Ten-Tec reflector, and I
am forwarding a copy of your email to them. They should be able to give you an
answer to your problem. I will forward any replies to you.
73, es GL
Ron Castro
N6IE
www.N6IE.com
Member:
ARRL
Redwood Empire DX Assn.
Northern California Contest Club
Northern California DX Foundation
Society of Broadcast Engineers
-----Original Message-----
From: bob-on4ldl [mailto:robmichaux@voo.be]
Sent: June 27, 2015 11:54 AM
To: ron@n6ie.com
Subject: infos
hello Ron
I search information on TENTEC Orion II 566 AT especially the technical manual
I explain, making the updated firmware I had a power outage ( alternative
courant schutdown ) I try reprogrammed correctly updated firmware and here are
the symptoms
Test update with 2 differents PC and differents cables without any result ,
port com OK
Update start very slowly and after about 10 minutes windows give "
windows update can't continue to run"
For information during last update a power shut down appear and upgrade stopped
before complete process .
Have you idee about this issue ??
Wait for your answer
Or I want a procedure to put it into state Tentec setup AT 566 Orion Program
Best regards
Robert ON4LDL - Amateur radio enthusiast Tentec
|