| To: | "TenTec@contesting.com" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] 540/Triton Transmit Audio Distortion |
| From: | Bill Acito <w1pa@hotmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 4 Apr 2015 18:12:55 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I have a Delta and Omni-A, so I am setting the ALC/Drive correctly. I'll try
taking the finals out of the equation. I also note there are bias settings on
both the finals and the OT-TR assembly that I will look at. Anything else that
could be causing overdrive with correct ALC/Drive settings on the front?
I keep getting these rigs where it looks like folks went in with a golden
screwdriver and tried to get 500W out of 100W rigs...
Bill W1PA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] TenTec Digest, Vol 148, Issue 7, Paul DeWitte |
|---|---|
| Next by Date: | Re: [TenTec] 540/Triton Transmit Audio Distortion, Reed Krenn |
| Previous by Thread: | Re: [TenTec] 540/Triton Transmit Audio Distortion, Rick - DJ0IP / NJ0IP |
| Next by Thread: | Re: [TenTec] 540/Triton Transmit Audio Distortion, Reed Krenn |
| Indexes: | [Date] [Thread] [Top] [All Lists] |