| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni D issue |
| From: | Mike Bryce <prosolar@sssnet.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 8 Oct 2014 20:13:41 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Check the bias voltage, too The circuit is supposed to track thermal increases from the PA transistors and adjust the bias voltage. Mike wb8vge Sent from my iPhone > On Oct 8, 2014, at 7:17 PM, Robert <rmcgraw@blomand.net> wrote: > > Bypass cap issues in the PA likely allowing the PA to break onto oscillation. > > Bob, K4TAX > > > _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Omni D issue, Robert |
|---|---|
| Next by Date: | Re: [TenTec] Another retro question - Argosy-Century, Al Gulseth |
| Previous by Thread: | Re: [TenTec] Omni D issue, Robert |
| Next by Thread: | Re: [TenTec] Omni D issue, Wade Staggs |
| Indexes: | [Date] [Thread] [Top] [All Lists] |