| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Orion 565 tuning encoder |
| From: | shristov <shristov@ptt.rs> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 21 Jun 2014 19:23:13 +0200 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Barry N1EU <barry.n1eu@gmail.com> wrote: > Thanks Sinisa. vfoB would not tune at all. I had the same problem. VFO B encoder had a supply voltage of only 4.66 V. After tightening 4 fixing screws on the A9 board, the voltage at encoder rose to 4.77 V and it started workig. 73, Sinisa _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Orion 565 tuning encoder, Barry N1EU |
|---|---|
| Next by Date: | Re: [TenTec] Orion 565 tuning encoder, Barry N1EU |
| Previous by Thread: | Re: [TenTec] Orion 565 tuning encoder, Barry N1EU |
| Next by Thread: | Re: [TenTec] Orion 565 tuning encoder, Barry N1EU |
| Indexes: | [Date] [Thread] [Top] [All Lists] |