Hello.
I wrote and posted the pictures their on the Wiki.
Its has been over 3yrs without a problem. Please
note that the Orion sits in a rack and rarely taken out.
All of my cabling for the rigs are done thru the back of
the rack and have bumped against the Power Poles.
Never has it come out nor have I needed to reseat it.
Same for the Jupiter. The Jupiter doesn’t stick out on
the back as the Orion though.
Oh.. I have also installed PP on the KWM-380 (separate
Cinch Jones connector wire for 12V) and
the Hercules II (two sets of 45amps in parallel).
The RX-340 does not lend itself well for 12VDC, hi..
I’m happy with the Power Poles.
Others might have had different experiences.
Fernando N2FQ/6
n2fq@sbcglobal.net
On May 9, 2014, at 11:48 PM, PA5MW, Mark <pa5mw@home.nl> wrote:
>
> The tricky part is soldering the correct length of the copper wire
> crimped-soldered to the the PP inner part and implement that soldered end on
> the board at the exact length, so the outer PP connector housing seats flat.
> If you are not experienced in soldering/tooling, get some help.
>
> 73 Mark, PA5MW
>
> Look at:
>
> https://www.flickr.com/photos/pa5mw/11384683803/in/photostream/
> https://www.flickr.com/photos/pa5mw/11384552076/in/photostream/
> https://www.flickr.com/photos/pa5mw/11384546215/in/photostream/
> https://www.flickr.com/photos/pa5mw/11384683273/in/photostream/
> https://www.flickr.com/photos/pa5mw/11384551726/in/photostream/
> https://www.flickr.com/photos/pa5mw/8728473367/in/photostream/
>
>
>
>
> I have also seen the Power-Pole modification Wiki. For those with some
> history on that, how has that worked out for you? Can anybody offer a parts
> list? I am a total newbie to Power-Pole connectors. Thanks in advance for
> your efforts and information.
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|