| To: | <n4py3@earthlink.net>, "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Paragon II and 301 Remote |
| From: | "Steve Garwood" <n0czv@frontier.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 8 Nov 2013 10:32:03 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Carl, I had read that in archives, but I have not found any original documentation. The connectors are wired differently - my first fail point was not having 5 VDC on the encoder. My assumption is that the Paragon II will need lines added to support the 301. Searching for additional information now..... Steve, N0CZV Attica, Ohio n0czv@frontier.com -----Original Message----- From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Carl Moreschi Sent: Friday, November 08, 2013 7:41 AM To: Discussion of Ten-Tec Equipment Subject: Re: [TenTec] Paragon II and 301 Remote Yes the 301 knob will work with the Paragon II. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Paragon II and 301 Remote, Steve Garwood |
|---|---|
| Next by Date: | Re: [TenTec] Paragon II and 301 Remote, Mike Bryce |
| Previous by Thread: | Re: [TenTec] Paragon II and 301 Remote, Carl Moreschi |
| Next by Thread: | Re: [TenTec] Paragon II and 301 Remote, Mike Bryce |
| Indexes: | [Date] [Thread] [Top] [All Lists] |