Clayton,
The 10/32 screws may perhaps fit but the Russians use the metric system.
The screws are standard M5 (5mm).
I'm sure you can get these in most hardware stores in the states.
I recommend using the original screws.
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Clayton
Brantley
Sent: Sunday, October 27, 2013 7:04 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Model 238 / 229 Caps Mod (again)
My caps also didn't have any screws. I used 10/32 screws that worked great.
Be careful to use the correct length. I had one of the threaded ends come
loose.
I had the reheat it and worked great. I did the mod and the tuner works
good.
73 Clayton N4EV
On Sunday, October 27, 2013 5:37 AM, Rick - DJ0IP / NJ0IP <Rick@DJ0IP.de>
wrote:
I ordered 4 caps directly from the Ukrain.
They arrived yesterday - 12 days after I ordered them.
Look good, but no screws.
The screws are standard "M5".
I ordered a pack of 25 screws on ebay for a few bucks.
I paid $29.05 including shipping for the 4 capacitors.
73
Rick, DJ0IP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|