Yes, that will work. But if you're contesting, you're probably using N1MM
Logger software and no such display is provided.
I suggested many times that Elecraft provide a simple parameter display
utility but it never happened.
Barry N1EU
On Fri, Oct 18, 2013 at 7:48 PM, Richards <jrichards@k8jhr.com> wrote:
> Interesting observations, Barry... Gives me cause to pause and ask:
>
> What if you use a program like N4PY produces,
> or HamRadioDeluxe, or some other control program
> that might display that additional data - even
> if you are a knob guy like Cecil K5DL, could
> you use one of these programs just for what it
> can DISPLAY, and then control the rig from its
> front panel?
>
> I do that with N4PY and my TT Omni VII and my
> KW TS-590s -- I prefer knobs, dials,and buttons
> but like the display the software provides.
>
> Or is this distracting, having to watch the
> screen to monitor or track settings, and then
> operate the rig by the front panel controls?
>
> -------------------- K8JHR ----------------------
>
>
>
> On 10/18/2013 3:04 PM, Barry N1EU wrote:
>
> The form factor of the K3 means a lot more space on the desk but a lot
>> less
>> space on the display - no full time display of important parameters like
>> bandwidth, shift, power, mic gain/compression, monitor level, etc etc.
>> You
>> have to push a knob to see each value. And no parameters at all are
>> visible about the subreceiver unless you switch the display from main to
>> sub. There's plenty to like about the K3 and contesters have adopted it
>> in
>> droves, but the form factor doesn't work for me.
>>
> ______________________________**__________
>
>
>
>
> ______________________________**_________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/**mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|