I would think that if you enable the filter and it is NOT installed, then
you wouldn't hear any signals when the BW was set where that filter should
be active. The rx signal path would be open where that filter should have
been sitting.
Barry N1EU
On Fri, Oct 11, 2013 at 12:05 AM, Richards <jrichards@k8jhr.com> wrote:
> Simple question No. 209083
>
> Re: Orion II Option Filters:
>
> Is there a way to verify one has either or both optional CW filters
> installed - and working properly - without opening the box?
>
>
> Thanks.
>
> ---------------------
> ______________________________**_________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/**mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|