[TenTec] Orion II SAF issue when left on and power down then power up

[Mike Chatfield <mikechat@embarqmail.com>]

I am running version 3.033xa just installed a couple of days ago. I 
noticed an interested problem with the SAF.
If I leave SAF (Main Receiver) on and power down, then bring the Orion 
II back on I get NO receive audio (mostly just popping noise) on the 
Main receiver. In order to get the audio to work I must shut off SAF 
then do a power cycle, it works fine then.
As long as I remember to shut off the SAF BEFORE powering off everything 
works fine.
As anyone seen this issue?
Not a big deal but it looks like a firmware issue...

Mike
W0BBC

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec