| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Adapting a Kenwood mic to Ten Tec Scout |
| From: | Stuart Rohre <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 26 Jul 2013 16:29:35 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
A couple of corrections in my post "mail" should be male.the impedance change is done where the mike cable plugs into the Kenwood mike tube, not on the desk base itself. Just ignore if you were not asking about a desk mike converting to a Scout. Stuart K5KVH |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Adapting a Kenwood mic to Ten Tec Scout, Stuart Rohre |
|---|---|
| Next by Date: | Re: [TenTec] [TenTec_Eagle] Re: Just ordered my Eagle, n8ag |
| Previous by Thread: | Re: [TenTec] Adapting a Kenwood mic to Ten Tec Scout, Stuart Rohre |
| Next by Thread: | Re: [TenTec] Adapting a Kenwood mic to Ten Tec Scout, Jim Hicks |
| Indexes: | [Date] [Thread] [Top] [All Lists] |