Jim,
Can you change modes to USB using rig control software like HRD, N4PY or even
N1MM?
If so, that would also indicate a possible hardware button problem.
Rod/w7zrc
>________________________________
> From: Ted Bryant <w4nz@comcast.net>
>To: 'Discussion of Ten-Tec Equipment' <tentec@contesting.com>
>Sent: Sunday, June 2, 2013 9:43 PM
>Subject: Re: [TenTec] Orion II USB button not working
>
>
>The button used to select the "USB" mode is labeled "ATTN". It is a
>multifunction button depending on what is on the display beside it. Its
>normal function is to switch in attenuation. Does it work for this? If not
>then it likely is a problem with the button itself (or as suggested, a
>ribbon connector that serves this button). If it selects attenuation ok the
>button is working correctly and there is a problem elsewhere.
>
>73, Ted W4NZ
>
>
>
>-----Original Message-----
>From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of N4BE_Jim
>Sent: Sunday, June 02, 2013 9:40 PM
>To: tentec@contesting.com
>Subject: [TenTec] Orion II USB button not working
>
>The USB mode selection suddenly stopped working. I can go into any other
>mode but when I try to go back to USB it does nothing. Did clear and reset,
>even loaded an earlier firmware version, nothing. I'm thinking maybe a bad
>push button? Anyone ever had a similar problem?
>Jim N4BE
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|