| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] PTO rebuild question |
| From: | Barry N1EU <barry.n1eu@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 17 Apr 2013 22:32:11 +0000 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
oops, never mind, got it! Barry N1EU On Wed, Apr 17, 2013 at 10:25 PM, Barry N1EU <barry.n1eu@gmail.com> wrote: > Can somebody suggest a good method to remove the bearings from the > tuning shaft? One fell right out but the other two seem stuck. > > Thanks & 73, > Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] PTO rebuild question, Barry N1EU |
|---|---|
| Next by Date: | Re: [TenTec] Tuning Amp on 17 meters, Richards |
| Previous by Thread: | [TenTec] PTO rebuild question, Barry N1EU |
| Next by Thread: | Re: [TenTec] receivers: paragon vs. corsair II, Bwana Bob |
| Indexes: | [Date] [Thread] [Top] [All Lists] |