TenTec
[Top] [All Lists]

Re: [TenTec] New 703 Mic

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] New 703 Mic
From: John Huffman <hjohnc@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 03 Feb 2013 18:38:53 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Thanks for the interest. I'm happy with the way it is now. No project for me, but good luck if you go ahead.

73 de K1ESE
John


On 2/2/2013 2:04 AM, Richards wrote:
What would happen if you swapped the switch out?
I think that is what I would try to do, as the problem
continues but is, now, minimized.  You can use the
current switch until we determine a quiet replacement.

Is there any reason we could not scour the planet
and find a better, quieter switch?   I would pitch in
on that project.  It might assist others, as well.

Happy days.
______________  K8JHR  ____________________

On 2/1/2013 1:43 PM, John Huffman wrote:


I have minimized the button noise by snipping off a bit of the switch
plunger inside the mike.  Now the button activates the PTT just a bit
before its travel limit.  Thus, the noise and scratching the mic puts
out over the air is now restricted to that last bit of button travel.
___________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>