Have you done all the resets?
1) Power off Orion.
2) Power On holding the VFO B LCK button.
3) Continue holding LCK button until the radio says "Battery Failure".
4) Power off Orion.
5) Power on holding "Main RX/TX" button.
6) Continue holding this button until the radio says reset complete.
7) Do not clear any settings when asked to do so.
8) Power the Orion off and back on one more time.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 11/19/2012 1:27 PM, Barry LaZar wrote:
Has anyone had this problem? My Orion II no longer works with computer
control. It seems to have stopped about 45 or so days ago. I have
changed out control cables and USB to serial adapters with ones that I
know work. Everything else on the Orion II seems OK. Ideas before I open
her up and poke around?
Barry
K3NDM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|