[TenTec] Corsair II PBT

[K4MT <k4mt@yahoo.com>]

Thanks all for the feedback. Thanks to Paul at Tentec for the reply. I think I 
can see what Paul is saying about the BFO adjustment and how it will not allow 
the sound to be the same on SB-N and SB-R. 
But Paul if I follow the alignment in the manual as you suggest, then how do I 
adjust L4 on the PBT board? It says to adjust L4 until SB-N and SB-R sound the 
same when switching between them. Since you said this can not be the case, what 
is the proper L4 adjustment? 
I would call you but it sounds like the answer might help the entire group if 
you could post it here as there seems to be some confusion.
Thanks