| To: | Tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Omni C TX/RX drift |
| From: | w8au@sssnet.com |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 17 Aug 2012 07:12:53 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
At 10:54 PM 8/16/2012, you wrote: I had a comment while on the CW traffic net 40 meters tonight that my tx was drifting up and down a little while transmitting on my Omni D series C. I could also hear the freq shift in the receiver. I guess it is intermittent, but where should I start looking to trouble shoot this issue? Take the bottom off, use cramolin or solvent on the bandswitches. That clears if for my OMNI CPerry w8au |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] new amp, Rick - DJ0IP / NJ0IP |
|---|---|
| Next by Date: | [TenTec] New amp, Dave Garner |
| Previous by Thread: | Re: [TenTec] Omni C TX/RX drift, Mike Hyder -N4NT- |
| Next by Thread: | [TenTec] Audio Pad for RX-340 -> Laptop?, Scott Walker |
| Indexes: | [Date] [Thread] [Top] [All Lists] |