Hi Ben...
Do you have any way of checking the ripple on your PS? Sounds like some AC
may be tripping your Logic Board.
Can you try another supply?
Phil C. Sr.
k4dpk
----- Original Message -----
From: "Ben Hall" <kd5byb@kd5byb.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, July 13, 2012 8:53 PM
Subject: [TenTec] Paragon Problem
Good afternoon all,
I've got a Ten-Tec Paragon (with matching 962 power supply) that is
having a problem and I'm hoping there is an easy fix that doesn't
require a trip back to the factory for repair.
Here's what happens - when I turn it out, all of the LED indicators
light up for a split second and then it turns off. The power LED on the
power supply goes off at the same time.
I disconnected the power supply, jumpered the two center pins, and its
putting out a nice 13.80 volts. Even under a 15 amp load (the highest
my electronic load will do!) its still putting out 13.3 volts.
Depressing the reset button does nothing.
Thoughts?
thanks much and 73,
ben, kd5byb
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|