| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Argosy testing |
| From: | John <jh.graves@verizon.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 23 Feb 2012 10:35:13 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
I have been able to move the back panel out enough to at least see the
final amplifier board. I am trying to figure out a safe way to insert a
ammeter into the power line to the final. Not there yet.
As an aside, it appears that someone has added a 1000 mf electrolytic to ground across the power line (red) to the final. This does not appear in the schematic that is in the manual. Was there a problem with early Argosys that this was meant to cure? -- John / WA1JG |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Argosy Latching Switch, Joe |
|---|---|
| Next by Date: | Re: [TenTec] Argosy testing, Mike Bryce |
| Previous by Thread: | [TenTec] Argosy Latching Switch, Joe |
| Next by Thread: | Re: [TenTec] Argosy testing, Mike Bryce |
| Indexes: | [Date] [Thread] [Top] [All Lists] |