TenTec
[Top] [All Lists]

Re: [TenTec] OT: Scopes

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OT: Scopes
From: Dave Edwards <kd2e@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 19 Feb 2012 15:05:58 -0500
List-post: <mailto:tentec@contesting.com>
high 100's to mid 200's.
I had a cherry HP 1726A scope that was mine at work. But, I used a cheaper 1740A, and the 1726 was like new.
I sold it.
To friggin big, and too much of a risk when something goes belly-up.
I now have a small lightweight Hitachi, and a digital Tek....both of them very small and lightweight. Whatever the specs on them compared to the old HP??? Don't care, they do everything I need done.

.....Dave





On 2/18/2012 10:16 PM, kc9cdt@aol.com wrote:
Dave,
How much are we talking??
73,
Lee



-----Original Message-----
From: Dave Edwards<kd2e@comcast.net>
To: Discussion of Ten-Tec Equipment<tentec@contesting.com>
Cc: tentec<tentec@contesting.com>
Sent: Sat, Feb 18, 2012 6:29 pm
Subject: Re: [TenTec] OT: Scopes


Having worked for HP/Agilent, you'd think I'd be pushing one of
them...or a Tek
version. If you can find a nice one...great!  But I gotta tell
'ya....the cheap
Chinese ones are now lookin pretty darn good. LCD displays, and ability
to save
an image as a .jpg on a thumb drive!   If I was suddenly scope- less,
(and every
ham needs a scope)....I'd be looking at one!
...Dave

Sent from my iPad

On Feb 18, 2012, at 2:14 PM, "Hulett, Russell"
<rhulett1@consolidated.net>
wrote:

I've avoided owning a scope, but the recent discussion about
troubleshooting
low power from an Omni D has me rethinking.  Most of the gear I own now
old,
have managed to diagnose problems without owning a scope.  In one case,
the
problem with an old hollow-state receiver was found by poking around
with a
wooden dowel to expose a poor solder joint.  My main concern is
spending more
money on a scope than my shack is worth, or alternately spending more
time
fixing a used scope than is warranted.
Would be curious about thoghts from others who repair their own gear
about
what minimum-required scope would be.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>