TenTec
[Top] [All Lists]

Re: [TenTec] WTB Argosy

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] WTB Argosy
From: "J. W. (Dub) Thornton" <dub@atlinkwifi.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 18 Feb 2012 10:21:00 -0600
List-post: <mailto:tentec@contesting.com>
Hey Joe:

I have been watching your search for the ideal "farm" rig. I have an Argosy 525 Digital that would possibly suit your needs. It looks purty good for a rig of its age. Front panel is fine, top has a few small scratches in the paint, nothing big. It puts out full power. Has a couple of mods I have done. I replaced the A.F. power pot, with a dual concentric pot so I could add RF gain, which it badly needs. I also installed the 10 amp, fast acting circuit breaker in the rear panel, which is necessary when not using a Ten Tec power supply, to protect the finals from drawing too much current. I would like $250.00 for the radio. I have the matching Ten Tec PS as well, however, I always carried a small, surplus, rack mount PS that can usually be found at hamfests for $10.00 or less. With the fast acting circuit breaker I have mounted in rear panel, you can use any 12/13.8 volt PS, and the radios finals will be protected from over current draw. I can send pix, if desired? 73 Dub

At 04:58 PM 2/17/2012, you wrote:
Analog or Digital. Contact off-line.

Joe
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

--
J. W.  (Dub) Thornton  K5DUB
Minco, OK.

<Prev in Thread] Current Thread [Next in Thread>