| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Orion s-meter calibration |
| From: | Carl Moreschi <n4py2@earthlink.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 31 Dec 2011 08:54:51 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
It's all done in firmware. My software provides this but it's only for the program S meter. Carl Moreschi N4PY 121 Little Bell Dr. Hays, NC 28635 www.n4py.com On 12/31/2011 8:47 AM, Barry N1EU wrote: > Does anyone know the procedure for calibrating the Orion s-meter? Are > there hardware pots that can be adjusted? > > Thanks& Happy New Year, > Barry N1EU > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec > _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Orion s-meter calibration, Barry N1EU |
|---|---|
| Next by Date: | Re: [TenTec] OT: Old QSTs, CQs, etc., denton |
| Previous by Thread: | [TenTec] Orion s-meter calibration, Barry N1EU |
| Next by Thread: | Re: [TenTec] Orion s-meter calibration, Ron Castro |
| Indexes: | [Date] [Thread] [Top] [All Lists] |