| To: | k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Yamaha CM-500 boomset use with Orion II? |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 08 Dec 2011 23:35:26 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I am building one for myself, but the guys at the contest station like the manufactured pads, as they are so blasted convenient. I am making my own adapters, with variable resistors (pots) that may allow me to vary the attenuation to use different mics on different rigs. ========================== JHR ================================= On 12/8/2011 3:19 PM, Jim Brown wrote: > If you know which end of a soldering iron to pick up, a 10dB pad is two > resistors, at a few pennies each. > ______________________________________________________________ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Yamaha CM-500 boomset use with Orion II? <Jupiter>, John |
|---|---|
| Next by Date: | Re: [TenTec] Yamaha CM-500 boomset use with Orion II? <Jupiter>, Jim Brown |
| Previous by Thread: | Re: [TenTec] Yamaha CM-500 boomset use with Orion II? <Jupiter>, Jim Brown |
| Next by Thread: | [TenTec] Information Sharing: Curing a Corsair I Drift Problem, N6QW |
| Indexes: | [Date] [Thread] [Top] [All Lists] |