Make sure you have the very latest firmware from tentec.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 11/28/2011 3:27 PM, BUDW2GLN@aol.com wrote:
I have a model 550 Pegasus and I am using the standard software that TenTec
provides. I have several pieces of TenTec gear but have been spending a
lot of time using the 550...I am fascinated with it.....
I brought it up on ten meters for the first time the other day and noticed
that I had only a couple of watts maybe 3 out on AM with the power level up
at max. Further investigation revealed that SSB and CW output were A OK on
all bands......BUT to achieve 25 watts AM, the 80mtr AM setting was
normal.....40mtrs required 2/3 setting...... 20mtrs required full setting
.....15mtrs would give out aprox 8 watts at full setting and, as I said, 10mtrs
almost no output.........Any suggestions ???
Thanks
Bud W2GLN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|