Is the problem present on SSB (normal), SSB (reverse), or CW? Or all 3?
Steve G3TXQ
On 21/11/2011 02:13, scottsheppard@videotron.ca wrote:
I just recently picked up a lovely Corsair II (to add to the TT madness) and
the DDS kit from N4YG,,,the difference, by the way, is amazing and makes the
rig an even greater pleasure to use than before.
Upon installing it and actually using the rig a bit, however, I note that my Tx
and Rx freq are not aligned. Its not that the rig display may be a bit off but
rather the station signal I am listening to is on one freq and when I transmit
back, I am about 600hz off (as though working split--which I am not), I did not
adjust anything else after the install but the issue may have been pre-existing.
Seems to me I had similar issues on an older Omni A but don't recall what I
tweeked or balanced...any thoughts from the Corsair crowd?
73
scott va3ied
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|