Have you perchance considered ordering a kit of PTO rebuild parts from
Ten-Tec and overhauling the poor PTO?
73, Mike N4NT
----- Original Message -----
From: "Hulett, Russell" <rhulett1@consolidated.net>
To: <TenTec@contesting.com>
Sent: Wednesday, November 16, 2011 6:20 PM
Subject: [TenTec] Omni D PTO Swap
If I remove the entire PTO assembly from one Omni D and install in
another, are there any adjustments needed other than the L1, L2, & L3
adjustments on the PTO to set the oscillator endpoints and linearity? I
have one rig with a smooth PTO but numerous "issues" otherwise, another
with poor PTO but no "issues" otherwise.
Thanks in advance & 73, Curt KB5JO
|