Yes, that is what it says. The only problem is that every online manual I
have seen does not have that page.
----- Original Message -----
From: "Richards" <jruing@ameritech.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, November 06, 2011 8:12 PM
Subject: Re: [TenTec] OMNI D Accessory Jack Pinout
One of the manuals I have says the pin outs are explained on the MIN
BLOCK DIAGRAM.
Maybe this helps... depending on if you can find the
main block diagram...
========================= James -K8JHR ========================
On 11/6/2011 8:46 AM, Joe wrote:
I need to know the pinout of the 9-pin OMNI D accessory jack. I have
looked a several of the online manuals and everyone is missing the block
diagram which has this information. I am guessing that it is the same as
the Corsair II. If someone could give me the info or point me to a
complete manual I would appreciate it.
------------------------------------------------------------------
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|