Say Scott,
First, are you working with and Argonaut V (model 516)? IF so, where is
that switch on the back for high and low position?
I have fiddled with the pots on the inside of the Argonaut V and can also
reach those lofty levels of 40 Watts, but i NEVER HAVE LEFT IT THERE.
Kris KM2KM
> I have been doing some work on my Argosy and would appreciate anyones help
> on increasing the power output...the issue seems to be more on the low
> power side than when teh PA is switched on (its a low/hi power setting on
> back up to 50 w)...I have gone thru and adjusted the bias for the low
> level and PA--all to spec
>
> my out puts are as follow
>
> low setting high setting
>
> 80 1w 45w
>
> 40 3 w 50w
>
> 30 2.5 w 50w
>
> 20 2.5w 20w
>
> 15 1w 25w
>
> Not the end of the worss but i would like to run it in the low switched
> position with about 4 or so watts if possible. Appreciate any tips others
> may have.
>
> cheers
>
> scott va3ied
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
Merschrod
Briançon, France through 2 NOV
After 3 NOV Ithaca 607 257-1734
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|