Re: [TenTec] Omni 6+ RIT Tuning Rate

[Michael Tope <W4EF@dellroy.com>]

Sure enough. That did the trick. Thanks Gert and Barry!

73, Mike W4EF...........

On 9/11/2011 6:58 AM, Barry N1EU wrote:
> rSPD sets SSB RIT rate and CrSP sets cw RIT rate.  OP set SSB rate
> instead of CW rate.
>
> 73, Barry N1EU
>
> On Sun, Sep 11, 2011 at 1:17 PM, Gert Meinen<pa3aav@hetnet.nl>  wrote:
> > Mike,
> >
> > In my Omni VI opt 3 there is in menu 3 the option CrSP this sets the rate of
> > the offset tuning knob in CW mode in kHz per turn  from 4.8 to .15 kHz in
> > six steps.
> >
> > Hope this helps,
> >
> > 73 Gert, PA3AAV
> >
> >
> > ----- Original Message -----
> > From: "Michael Tope"<W4EF@dellroy.com>
> > To:<tentec@contesting.com>
> > Sent: Sunday, September 11, 2011 12:30 PM
> > Subject: [TenTec] Omni 6+ RIT Tuning Rate
> >
> >
> > > My frustration with the fast tuning rate on my Ten-Tec Omni 6+ RIT
> > > function finally exceeded my "I should do something about this"
> > > threshold last night during the CW Sprint contest. I just changed the
> > > setting in the hidden options menu 3 (i.e. rSPD) from 4.8 KHz/turn to
> > > 0.15 KHz/turn. This didn't have any effect on the tuning rate. Is there
> > > a hardware and/or firmware change that is required to make this
> > > particular menu parameter function properly?
> > >
> > > Thanks,
> > >
> > > Mike W4EF.......................
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec