TenTec
[Top] [All Lists]

Re: [TenTec] Correction

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Correction
From: Carl Moreschi <n4py2@earthlink.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 05 Jul 2011 18:33:17 -0400
List-post: <mailto:tentec@contesting.com>
The real question is is the filter 200 hertz off or is your impression of the same tone 200 hertz off. Only the 250 filter would be narrow enough for this to show up.

You need a second radio to see if the filter is off. Tune in the same signal on both radios. Center the signal in the 250 filter and then transmit at very low power and see if your signal matches the receive test signal in pitch.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 7/5/2011 6:28 PM, Keith Hamilton wrote:
I made a typo in my question. I meant to say I must tune the radio from 
7.040.00 to 7.040.20 to center the 250 hz filter.
Sorry
Keith W8GX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>