| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Fwd: Model 715 question |
| From: | Barry N1EU <barry.n1eu@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 26 May 2011 20:15:57 +0000 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
On Thu, May 26, 2011 at 5:22 PM, Richards <jruing@ameritech.net> wrote: > Thanks, Barry. > > Yes ... however, if I understand your suggestion, that will not supply > the required bias voltage, just provide a connector for it - I still > need a source for that voltage. +10V at pin 2 of the 715 mic connector. Didn't you see p2 of the 715 manual? 73, Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] 1/8 inch plug, Paul DeWitte |
|---|---|
| Next by Date: | Re: [TenTec] Fwd: Model 715 question, Barry N1EU |
| Previous by Thread: | Re: [TenTec] Fwd: Model 715 question, Richards |
| Next by Thread: | Re: [TenTec] Fwd: Model 715 question / Yamaha CM500 bias, pfizenmayer |
| Indexes: | [Date] [Thread] [Top] [All Lists] |