Rule 1: There is no free lunch.
Rule 2: If someone offers you a free lunch, see Rule 1.
Note that if you enable a notch within the pass band of the signal
you are listening to, everything within the notch will disappear,
including the part of the desired signal that is within the notch.
That may lead to distorted-sounding audio.
Have you tried notching the carrier with the manual notch?
Kim Elmore N5OP
At 09:23 PM 1/31/2011, you wrote:
yes but I need it when I have a carrier next door to me. And is it not what
the AN is for.
-----Original Message-----
From: N4PY2
Sent: Monday, January 31, 2011 9:43 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] auto notch
Turn it off.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "ROD" <w3krq@dejazzd.com>
To: <TenTec@contesting.com>
Sent: Monday, January 31, 2011 9:13 PM
Subject: [TenTec] auto notch
> what is the fix for distorted audio when the auto notch is on at level 1
> The kenwood radio did not distort audio when bc was on
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|