The Delta does not have a 9 mhz IF. It has two IF's with the last one being
6.3 mhz. The Delta has not problems at all transmitting on 18 mhz with the
mixing scheme it uses.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Dr. Gerald N. Johnson" <geraldj@weather.net>
To: <tentec@contesting.com>
Sent: Friday, January 28, 2011 5:16 PM
Subject: Re: [TenTec] WARC band crystal part numbers
6.3 MHz is only used in the receive chain for Pass Band Tuning. Not in
the transmitter line. I think. I've not had a delta or a delta manual.
I'll stick by what I wrote in 2003. If you have to go to the inverted
sideband for USB on 18 MHz there's no spur problem, if not there is a
transmitter spur problem.
73, Jerry, K0CQ
On 1/28/2011 2:27 PM, Bill Acito W1PA wrote:
Found it:
http://lists.contesting.com/archives//html/TenTec/2003-08/msg00359.html
Yikes.
Delta should be fine with the 6MHz IF, correct?
Bill
W1PA
Is that correct? (haven't had a chance to search the archive yet, but I
remember
something about "putting out a watt or two, even on receive")
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|