Have you reset the Jup? There are goblins in that setup that can come out of
the dark and blindside you. I think I had my encoder act up one time and it
was solved with a reset of the rig.
Mark Milburn KQ0I
Des Moines, IA
on Skype as: markkq0i
On Mon, 24 Jan 2011 13:33:09 -0800
"Keith Flint" <kcflint@wirelessbeehive.com> wrote:
>I have a remote Encoder/Keypad model 302 that is acting up. Ten-Tec
>says it is not economical to repair.
>
>It will not increment the frequency dial on my Jupiter 538 properly,
>the digits flash in the .xxx range, and sometimes in the megahertz and
>kilohertz range.
>
>It looks line the actual encoder with the rotatable shaft and knob on
>it are working, but
>
>I think one or more of the chips on the board might have taken a hit
>from static or something. My Jupiter dial works fine, so it is just in
>the Keypad.
>
>Anybody ever troubleshoot one of these?
>
>Thanks
>
>Keith
>
>W7ZAC
>
>offline please use http://www.qrz.com/db/w7zac web email address.
>Thanks
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|